Nikon RADIUS CM200 Uživatelský manuál stáhnout pdf (Strana 18)

2-4 MAINTENANCE

6.0 Radio Disassembly - Detailed

The procedure to remove and replace a Control Head, Top Cover or Transceiver Board is similar for

all models of radio. A typical procedure is therefore shown followed by specific disassembly

procedures for Control Heads on radio models without a display and radio models fitted with a

display.

6.1 Control Head Removal

Volume Knob Removal

1. Insert the flat screwdriver between the control head plastic and the volume knob and push the

volume knob upwards. See Figure 2-1.

Figure 2-1 Volume Knob Removal.

2. Insert the flat screw driver (4 mm maximum) into the slot and push the plastic up.

Do the same with the second slot to free the control head from the chassis assembly. See

Figure 2-2.

NOTE

Ensure that the volume knob is in the OFF position before disassembling the radio.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 69 70

Žádné komentáře

Nikon RADIUS CM200 Uživatelský manuál Strana 18